IEI Laboratories for AMIE Students

The task of construction and procurement of equipment for the following four labs for usage by AMIE Students was entrusted to ESCI by IEI HQ sanctioning an amount of Rs.1.95 Crores with an objective to enable the AMIE students appearing for Section-B Examinations to undergo practical training as per syllabus as well as to conduct experiments.

  • Civil Engineering
  • Electrical Engineering
  • Mechanical Engineering
  • Electronics & Computer Science Engineering

Accordingly, four buildings were constructed and the following labs have been set-up:

  • Civil Engineering
  • Electrical Engineering
  • Mechanical Engineering
  • Electronics & Computer Science Engineering
  • 3-D Printing – Design & Prototyping Centre

Civil Engineering Lab

Equipment pertaining to Geotechnical, Concrete, Transportation, Environment & Public Health Engg have been procured and installed.

RE RE

Electrical Engineering Lab

RE RE
SNoEquipmentQty(Nos.)
1 Coil Connection and Ratings of a Single-phase Transformer 1
2 Study of a DC Motor Starter and Speed Control of Shunt Motor 1
3 Over Current Relay 1
4 Characteristics of Single Phase AC Series and Parallel Circuits 1
5 Verification of Thevein’s and Norton’s Theorems 1
6 Balanced Three-phase Circuit 1
7 Parallel Operation of Three-phase Transformers 1
8 Synchronous Generator and Motor 1
9 Measurement of Low Resistance by Kelvin Double Bridge 1
10 Calibration of Three-phase Wattmeter and a stop watch 1
11 DC Power Supply: 220V / 100A DC with overload, over voltage, single phasing and phase reverse protections 1

Mechanical Engineering Lab

RE RE
SNoEquipmentQty(Nos.)
1 Thermal conductivity of given metal rod “Akero” make 1
2 Heat transfer in natural convention “Akero” make 1
3 Parallel and counter flow heat exchanger “Akero” make 1
4 Emissivity apparatus “Akero” make 1
5 Calibration of Venturimeter and Orifice meter (without mercury) 1
6 Determination of friction factor for a given pipeline (without mercury) 1
7 Rockwell-cum-Brinell testing machine 1
8 Electrical strain gauges tutor 1
9 Pendulum impact testing machine: mechanical version. Model ait-30, Capacity : 300 Joules 1
10 Static & Dynamic Balancing Apparatus 1
11 Whirling of Shaft Apparatus 1
12 Multi Stage Centrifugal Pump Test Rig 1
13 Performance Test on Kaplan Turbine Capacity 1 KW 1
14 Diesel Engine with electrical dynamometer to conduct heat balance test with exhaust Gas Calorimeter 1
15 Multi Cylinder Water cooled petrol engine Test Rig (Morse Test) 1
16 Cut Models for demonstration 10

Electronics & IT IMS Lab

RE RE

Design & Prototyping Lab

RE RE